Comments on: How to Make a Dado Jig for Palm Router

By: Stan

Stan — Sun, 24 Feb 2019 00:28:42 +0000

I like to use flush trim bits to cut dados. Form the template from two straight pieces spaced apart using the actual material for which you need the dado. For larger dados where you don’t have the exact size bit, used a smaller size, the spacing of the rails determines the width, not the bit.

By: Timisha Porcher

Timisha Porcher — Fri, 02 Mar 2018 18:51:40 +0000

In reply to Donald Kaiser. Donald its funny as I as using it I wondered the exact same thing LOL. But then I remembered why I only fixed one side. I had varying sized projects I needed to work on that required I use the router in two different ways.

By: Timisha Porcher

Timisha Porcher — Fri, 02 Mar 2018 18:49:37 +0000

In reply to David. Thank you so much Daivd. I'm so glad you took the time out to read through this article. Good luck in your woodworking journey.

By: Timisha Porcher

Timisha Porcher — Fri, 02 Mar 2018 18:48:10 +0000

In reply to Robin Edidin. Thank you so much Robin! So glad you found it all helpful.

By: David

David — Wed, 07 Feb 2018 17:16:40 +0000

Fairly new to woodworking and glad to have landed on this blog. One of the only two sites that I look up for any sort of idea. The one is a resource that gives me 10K+ new ideas for woodworking it can be checked here: http://bit.ly/2Dp8lpo, while yours helps me to understand how to go about my stuff. Will share once I have something decent to share.
Thanks once again Paul for such a detailed review post.”