Comments on: How to cut Crown Molding – Cutting Guide

By: Sandra

Sandra — Sat, 28 Mar 2020 11:59:01 +0000

In reply to Dave.

The crown moulding is cut upside down against the template. So saying, “Inside LEFT – Keep RIGHT piece” …when you turn the crown moulding right side up, the RIGHT piece becomes the left side of the joint.

By: Dave

Dave — Fri, 27 Mar 2020 01:55:41 +0000

Great tutorial, but there is an error on the template. Your “Inside L” and “Inside R” should be switched. The way it’s written would represent the board and not the joint … although, some people do refer to it that way because they find it easier to think about the board as opposed to the joint. Assuming you want your template to be consistent, and refer to the joint; the left side of the template should read “Inside R Keep L Piece” and subsequently, the right side should read “Inside L Keep R”.

By: MikeB

MikeB — Sun, 17 Feb 2019 02:07:00 +0000

Brilliant!

By: Sandra

Sandra — Sun, 09 Sep 2018 14:52:36 +0000

In reply to Harry. If you are doing an inside or outside corner changes which piece of the cut you use.

By: Sandra

Sandra — Sun, 09 Sep 2018 14:52:03 +0000

In reply to paula. It depends on if you're doing an inside or outside corner.